Top sellers

Thank you for purchasing your Nature Stone Protective Topcoat (Topcoat) DIY container. You apply the topcoat by rolling on with a paint roller. In addition to the Protective Topcoat, you may need the following items to complete your topcoat: 25-40: grit sandpaper, pressure washer (preferred) or hose, glove, dust mask, a 3/8 inch microfiber roller and paint tray, paint brush, bag of sand (for a non-skid surface.) For best results the area should be clean and dry before applying the Topcoat and the temperature should stay above 45 degrees for a full 24 hours after applying the Topcoat.

PLEASE NOTE: WHEN APPLYING THE TOPCOAT, MORE IS NOT BETTER! A THIN EVEN COAT SHOULD BE APPLIED. PLEASE READ ALL OF THE DIRECTIONS BEFORE STARTING.

STEP 1: Using the 24 to 40 grit sandpaper, lightly sand the area to scuff up any loose material on the top surface. Then, using the pressure washer (preferred) or hose, thoroughly clean the area and let dry completely; sometimes it can take a few days to dry. Reclaim any excess water from crevices with the shop vac.

Step 2: Put on gloves and dust mask

Step 3: Open your Topcoat container

Step 4: Using a brush, paint all wall lines, edges and wrap faces, around all drains and posts and/or any other intricate areas with the Topcoat.

 ROLLING, COVERAGE SHOULD BE 250 SQUARE FEET PER GALLON.

Step 5:  Dip the epoxy paint roller into the Topcoat and saturate.

Step 6: Roll the epoxy paint roller back and forth against the top of the paint tray to remove any excess material

Step 7: Lightly roll the epoxy paint roller back and forth across your floor making sure to cover the entire area and avoid any buildup or excessive roller marks (repeat steps 6 through 8 as many times as necessary) If excess is applied a new dry roller can remove it.

Step 8: (Optional non-skid surface)Place a pinch of sand and lightly to moderately, broadcast over the wet Topcoat that requires a non-skid surface. Repeat as necessary.

Step 9: Let any unused Topcoat in the paint tray harden for 24 hours and dispose of it in accordance with local regulations. Any topcoat left in the original container can be resealed and used at a later date before its expiration. (One Part Only)

Let Topcoat dry for a minimum of 24-hours and until the topcoat is no longer tacky. Keep vehicles off the freshly top-coated floor for one to two days.